- Nautilus Commercial TreadClimber TC916 Service Manual
- Nautilus T916 Owner's And Assembly Manual Addendum
- Product Manuals
- Nautilus t916 commercial treadmill owners manual
- Nautilus T914, T916 User Manual
- How to reset (re-calibrate) your treadmill
- Repair guides for treadmills
Nautilus Commercial TreadClimber TC916 Service Manual
Be Strong. Table of Contents. Page 5: Important Safety Precautions Close supervision is necessary whenever the machine is used by or near children, invalids, or disabled persons.
Failure to follow the conditions set forth below shall limit, to the extent allowed by law, Nautilus Inc. The console is the front, while the rear step is the back. Page 7: Mechanical Service Disconnect the 2 cables on the left side see Figure NOTE: To replace console, reverse instructions. Page 11 2 bracket screws.
Nautilus T916 Owner's And Assembly Manual Addendum
See Figure and Cylinder control cables located here. Page Belt Tension And Alignment To correct loosen tensioning To completely loosen belt if you want to start from adjustment screw. Page 17 2: rear cover and rear step removed.
Page 19 Check both the horizontal and the vertical bolts figure a-7 connecting the cylinder to the coupler and the coupler to the weldment of the pan. The bolts should be torqued to 75 ftlbs Nm.
See Figure A Move the treadles up and down until they come to a locked position. Page 21 9c With the treadles level and the encoder light on, tighten the set screw holding the large encoder wheel in place see Figure C Page 23 9e If the treadles do not lock parallel or close to parallel, then 1 recheck the center position on the encoder PCB section B ; 2 recheck the encoder range section D ; 3 recheck the treadle center in software section E.
Page 29 Check the center of the rear roller where the two halves join if there is any wobble the roller was not assembled correctly and needs to be replaced. Authorized Nautilus representitives will assist you with your specific service requirements. Items in the parts list highlighted in gray are replaceable.
Items with no warranty code or part number are replaceable as part of a higher-level assembly only. Page Exploded Views The reference numbers in the drawings on the following pages correlate to the reference numbers in the parts list on the preceding pages. Page Base Frame Covers right Side. Base Frame Covers: left side as you stand on unit facing console.
Treadle Deck and Belt assembly: Right side as you stand on unit facing console.
Nautilus t916 commercial treadmill owners manual
Treadle Deck and Belt assembly: left side as you stand on unit facing console. Page Treadle Arm Assembly right Side.
Treadle arm assembly: left side as you stand on unit facing console. Treadle Covers - Top and Bottom: Right side as you stand on unit facing console.
Nautilus T914, T916 User Manual
Treadle Covers - Top and Bottom: left side as you stand on unit facing console. Page Important Contact Numbers Important contact numberS If you need assistance, please have both the serial number of your machine and the date of purchase available when you contact the appropriate Nautilus office listed below.
Page 60 Model tc9.
Nautilus, Inc. All rights reserved.
How to reset (re-calibrate) your treadmill
Polar and Fantastic are registered trademarks of their respective companies. This manual is also suitable for: Be strong treadclimber tc Comments to this Manuals Your Name:.
Repair guides for treadmills
Enter text from picture:. Latest comments:. Print page 1 Print document 60 pages. Cancel Delete.
Sign in OR. Don't have an account? Sign up! Restore password.