Car Seat. Show quick links. Hide Hide permanently.
Table of Contents. Page 2 If you have any problems with your Chicco Child Restraint, or any questions regarding installation or use, please call: Chicco Customer Service Please have Model and Serial Number available when you call.
These are located on a label on the bottom of the Child Restraint. Child Restraints could be recalled for safety reasons. You must register this restraint to be reached in a recall. Page 7 30 lbs. Check Child Restraint for a snug fit in your car: While holding Child Restraint near belt path used, pull side to side and forward.
Why We Don’t
A loose harness could cause the child to be ejected in a sharp turn, sudden stop or crash, resulting in serious injury or death.
A snug strap should not allow any slack. If the airbag inflates, it can cause serious injury or death to your child. For vehicles with side air bags, refer to your vehicle owners manual for information on your child restraint installation. NEVER place carrier on beds, sofas or other soft surfaces.
Chicco KeyFit 30 Zip Infant Car Seat - Minerale
Page 15 A damaged Child Restraint may not protect your child in a future crash. Page Best Practices Child Restraint could slide and potentially cause serious injury. For more information, go to www. Please have Model and Serial Number available when you call.
How to Install a Car Seat Without Its Base (American Style)
The back seat is the safest place for children 12 and under. If in doubt, contact the vehicle manufacturer for assistance.
Why We Love It
Only forward-facing vehicle seats can be used with this Child Restraint. Make sure no more than 4 inches of the Do not use on a folded down Child Restraint base is past the edge of vehicle seat back.
If any of the belt types listed below are in the chosen seating position, choose another vehicle seating position or use LATCH if available. A premature infant may have difficulty breathing or have other medical problems when placed in a seated position.
When installing with LATCH, the unused seat belt should not be buckled behind the Child Restraint System as this will engage the inflatable portion of the belt. Pull vehicle seat belt down through the vehicle seat belt path on opposite side of the Base. Buckle the vehicle seat belt. Always use the Lock-Off on the opposite side of where the vehicle seat belt is buckled.
Pull vehicle seat belt down and slide into the Seat Belt Guide on opposite side of the Child Restraint.
Pull out all of the shoulder belt webbing and activate the locking mode of the vehicle belt. Seat Belt Guide A tightly rolled towel may be used under the front edge of the Carrier if needed to adjust the angle of the Carrier.
Chicco KeyFit Car Seats
Angle is correct when level line on Carrier is level with ground. Remove your child from the carrier and loosen the Harness Straps. Turn the Carrier over and locate the splitter plate. Re-attach Harness Strap to the Splitter Plate. Make sure both Harness Straps are at positioned at the same height, as shown.
See page 76 for more details.
Loosen harness by pressing the Adjuster Button and pulling out on both Harness Straps. Press the button on the buckle and release both buckle tongues.
If not, refer to page 60 for Adjusting Harness Height.
Chicco keyfit 30 infant car seat and base manual arts
NEVER use clothing or blankets that interfere with fastening or tightening the harness. An unsecured child could be ejected in a sharp turn, sudden stop or crash! Pull Harness Straps over child's shoulders and pull waist straps around their waist.
Pull up firmly on both Buckle Tongues to make sure that they are securely latched 6b. Fasten Chest Clip by snapping both sides together.
Chicco KeyFit 30 User Manual
Harness Straps must be laying flat, free of twists and on top of child's shoulders. Tighten the harness by pulling slowly on Harness Adjuster Strap while pulling up on both shoulder straps to remove all slack from below 8a. Make sure the Harness Straps are snug on child. If you can pinch a fold in the strap at the shoulders, the harness is too loose.
It lies in a relatively straight line without sagging. Heavy clothing can prevent harness from being properly tightened around child.
Page Newborn Positioner To ensure a better fit for smaller infants the Newborn Positioner may be needed. Do NOT use any other newborn positioner or pillows. Only use the one provided by Chicco for this Child Restraint. Place the Newborn Positioner in the Carrier seat.
KeyFit 30 Infant Car Seat - Orion
Then pull the Buckle through slot in the bottom of Newborn Positioner. Repeat for the other side. Not only will it protect your child during take-off, landing, and turbulence, but also allow your child to be more comfortable. Page Cleaning And Maintenance Hand wash using mild soap and water, or machine washed in cold water on delicate cycle using mild detergent. Hang to dry. For softgood removal instructions visit the Chicco website at www.
Page 85 Sponge clean using warm water and mild soap. Air dry. Do NOT machine wash. For proper removal and installation of the harness straps visit the Chicco website at www.
This manual is also suitable for: Keyfit. Comments to this Manuals Your Name:. Enter text from picture:. Latest comments:.
Print page 1 Print document 86 pages. Cancel Delete. Sign in OR. Don't have an account?
Sign up! Restore password.