Hussmann impact d5ele d5ee end cases to d5 parent case joining instruction 7 pages. Ultra low front rear load medium temperature dairy merchandisers 46 pages. Impact excel glass view end for multi-deck dairy merchandisers 12 pages.
All correspondence pertaining to warranty or parts ordering must include the serial num- ber of each piece of equipment involved, in order to pro- vide the customer with the correct parts. DO NOT allow air conditioning, electric fans, ovens, open doors or windows etc.
Sil fos 15 pdf files
Page 5: Plumbing and drain lines. See respective chapters for more detailed instructions.
After cases have been leveled and refrigeration, electrical, and waste piping work completed, install the splashguards. Use a 7mm allen wrench to turn the locks.
Page 6 The ASCS is capable of maintaining superb product qual- ity with the installation of the proper controlling devices. The humidity system should be properly maintained. Incorrect settings and failure to maintain the humidity system will result in short product life.
If not, check the follow- ing: 1. Make sure the water is feeding the nozzle. Remove the nozzle, and purge the water. Check the serial plate on the case for information. Locate first the electrical box, the outlets are then on the same side of the case but at the opposite end.
The ballasts for ledge lights are located in the fix- ture itself. To achieve the pro- tection required always: 1. Materials are available from local refrigeration wholesalers.
Hussmann DSF Installation And Operation Manual
Hussmann recommends using 15 Sil-Fos for repairs. The cylinders, which allow the opening and closing of the glass, have been carefully tested for proper tension.
Brazing Copper to Copper with Sil-Fos®
How- ever, during shipment, the lubricant inside may have settled. Page 14 3. Replace the bumper in the same orientation as it was removed.
Repeat as necessary. Slip rubber channel over straight edge of glass being inserted into clamshell 2. Page 15 Rev.
Hinge rod will protrude within the 6 inches, pointing to the outside of the glass. Tighten down allen screws with 3mm Allen wrench. Page 16 Tighten down uper piston hardware 1. Tighten down upper hardware with a 3mm Allen Wrench. Stores are responsible for setting their cases appropriately in conditions which vary from the above.
Sil-Fos 15 Phosphorus/Copper/Silver Alloy
Table 1 shows the typical temperature of the air entering the food zone one hour before the start of defrost and one hour after defrost for various categories of refrigerators. Page Appendix D. Hussmann reserves the right to inspect the job site, installation and reason for failure. This manual is also suitable for: Dsfm.
Metal joining products and services
Comments to this Manuals Your Name:. Enter text from picture:. Latest comments:.
Print page 1 Print document 24 pages. Cancel Delete. Sign in OR.
Don't have an account? Sign up! Restore password.